You can't just load the stuff from the machine disks last I knew. However, I think they had to pay for it with the machine buy. Offline software, if I remember right we did have it. It would take a cut that was impressive (for the nature of the machine), sometimes it was hard to keep the toolpost 'right' however:) 3. The one I used had a nice 'strong' motor, and gear drive. You could see the G code the machine generated from it's software but that was about all. Have an old computer with Dos 6.22 on it already.Īlso, does anyone know if this machine can be programed with g code? Raw Message Hi Dave, We had one of those where I used to work. It would be great if I could acquire a Desktop version of the software so I could practice programming at home. No one in the shop has any more than a casual knowledge of. Is there a Desktop or offline version of the software available?Īt work, I have been assigned the task of programming an old Bridgeport EZ-Path I lathe. No one in the shop has any more than a casual knowledge of programming this machine, and the boss claims that this machine/software is no longer supported. Raw Message At work, I have been assigned the task of programming an old Bridgeport EZ-Path I lathe.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |